LG Appliance Repair in Dallas, TX
LG repair for refrigerators, washers, dryers, and ranges. We handle linear compressor failures, ThinQ diagnostics, and error codes with OEM parts and same-day service.
1100+
Which LG appliances do we service?
All LG Lines: InstaView, ThinQ, WashTower & linear compressor models, all covered
LG Fridge & Freezer Repair
If your LG refrigerator isn’t cooling or the freezer temperature is inconsistent, our team can help. LG’s linear and inverter compressors can run nonstop yet leave the fridge warm — but a warm fresh-food section with a working freezer is more often a failed evaporator fan or defrost system. We diagnose on-site, service all LG models including side-by-side and French door units, and confirm whether the issue falls under LG’s extended compressor warranty before any work begins.
LG Dishwasher Repair in Dallas
LG dishwashers clean well, but poor drainage, standing water, or a grinding noise can develop over time. An OE code typically points to a blocked sump filter, drain hose, or pump, while spotty cleaning usually traces to clogged spray arms or a worn wash motor. We diagnose sensor faults, clear blockages, and replace failed pumps and valves with genuine parts, then confirm the unit drains fully under a real load before finishing.
LG Washer Repair in Dallas
LG washers are dependable, but a drum that won’t spin, water that won’t drain, or an OE error on the display can bring laundry to a halt. On LG front-load units, an OE code almost always traces to a clogged pump filter or a kinked drain hose, while a UE code means the machine couldn’t balance the load during spin. We diagnose the actual cause rather than swapping parts, and we handle the bigger jobs too — front-load drum bearings and torn door boot seals — with genuine LG components. Every repair finishes with a full test cycle so you see it working before we leave.
LG Dryer Repair in Dallas
A dryer that tumbles but won’t heat throws off your whole week. On LG units, that usually means a failed heating element, a tripped thermal fuse, or a thermistor fault showing up as a tE error. Flow Sense warnings (d80, d90, d95) point to restricted airflow, which also drags out drying times. Our technicians clear the full airflow path, replace whatever’s worn, and confirm the dryer is back to spec — across gas, electric, and heat pump models.
LG Stove & Range Repair in Dallas
When an LG range won’t heat or responds slowly, the cause is usually the heating element, the igniter, or the control board. A clicking igniter that won’t catch, a gas burner that won’t light, or an induction zone that won’t recognize cookware all trace back to a handful of components. Because cooktop faults can involve gas or mains voltage, we test and repair these safely rather than guessing — on electric, gas, and induction ranges alike, often the same day.
LG Oven Repair in Dalls
LG ovens can develop uneven baking, a failed element, or an F-code that stops them mid-bake. An oven that won’t hold temperature or throws an F1 or F3 error typically has a drifting temperature sensor, a failed bake element, or a control fault. We measure the sensor and element, replace whatever is out of spec, and recalibrate so the oven holds the temperature you set — on both standard and convection models.
Discount Coupon
Save on your next service with Home Appliance Repair Technician. Our primary aim is to make quality kitchen and laundry appliances as affordable as possible for everyone.
How we work
Brand-certified repair, done right the first time – your appliance back in service without the runaround.
Brands We Repair
Your reliable local partner for premium appliance repairs and expert maintenance.
Recently Completed Repairs
LG InstaView Fridge – Warm Despite Running Constantly
Lakewood, Dallas
THE PROBLEM: Owner noticed the fridge compressor never seemed to shut off, yet the fresh-food section was sitting around 50°F and milk was spoiling early. The freezer below was still holding solid.
THE FIX: The split symptom — freezer cold, fridge warm — pointed to the defrost system, not the linear compressor. The defrost heater had failed and ice had encased the evaporator coil, blocking airflow to the upper section. Cleared the ice, replaced the OEM defrost heater and bi-metal thermostat, and confirmed full airflow within the hour. Verified the compressor was still under LG’s extended warranty so the owner kept that coverage. On site: 1 hour.
LG Chest Freezer – Ice Cream Going Soft
Oak Cliff, Dallas
THE PROBLEM: A family kept a standalone freezer in the garage for bulk groceries. Through the summer it had crept from rock-solid to a soft, scoopable temperature — thawing slightly but never refreezing.
THE FIX: The thermostat was failing to cycle the compressor long enough to hold 0°F, made worse by 100°F-plus garage temperatures pushing the unit past its rated ambient limit. Replaced the OEM cold-control thermostat, verified the compressor and start relay were healthy, and confirmed it pulled back to 0°F under load. Advised on garage placement to protect the compressor long-term. On site: 90 minutes.
LG WashTower – Loud Roar Building on Every Spin
Knox-Henderson, Dallas
THE PROBLEM: Condo owner reported a deep roaring sound during spin that had grown louder over a couple of months, plus a faint burning smell after heavy loads.
THE FIX: The rear drum bearing had worn down, and the resulting wobble was starting to stress the shaft seal. Replaced the bearing and seal kit with OEM parts before it could leak and damage the stator, then ran two full spin cycles to confirm quiet, balanced operation. Catching it early saved a far more expensive motor repair. On site: 2.5 hours.
LG Electric Dryer – Runs Cold, tE Error
M Streets, Dallas
THE PROBLEM: Dryer tumbled normally but clothes came out cold and damp, and the panel flashed a tE error a few minutes into every cycle.
THE FIX: The tE code is a thermistor fault — the temperature sensor was reading out of range, so the control board shut off the heating circuit as a safety response. Confirmed the thermistor was out of spec, replaced it with the OEM part, then verified the heating element and thermal fuse were both healthy so nothing else was masked. Ran a full heated cycle to confirm proper drum temperature. On site: 75 minutes.
LG QuadWash Dishwasher – Clean Bottom Rack, Dirty Top
Bishop Arts, Dallas
THE PROBLEM: Homeowner reported the lower rack came out spotless while the upper rack still had food residue and detergent left in the cup, cycle after cycle.
THE FIX: The upper spray arm feed tube had cracked at the connection, dropping water pressure to the top rack to almost nothing — an easy issue to mistake for a failing pump. Replaced the OEM feed tube and upper spray arm, cleared mild limescale from the jets, and ran a full cycle with both racks loaded to confirm even coverage and a fully released detergent cup. On site: 1 hour.
LG Induction Range – One Zone Won’t Recognize Cookware
Preston Hollow, Dallas
THE PROBLEM: The largest induction zone stopped working after a brief power flicker during a storm – it beeped and showed an error instead of heating, while the other zones worked fine.
THE FIX: The voltage event had taken out the inverter board driving that zone. Confirmed the zone’s coil and sensor were intact, then replaced the OEM power inverter board for that element. Tested all four zones with compatible cookware to confirm full power and correct pan detection. Recommended a surge protector for the circuit. On site: 2 hours.
LG ProBake Oven – Bakes Unevenly, Throws F1
Lake Highlands, Dallas
THE PROBLEM: A baker reported cookies browning on one side and an F1 error appearing partway through longer bakes, with the oven sometimes cutting the heat before reaching temperature.
THE FIX: The F1 code traced to a drifting oven temperature sensor feeding bad data to the control board, which was shutting the bake element as a safety measure. Tested the sensor’s resistance against spec, replaced the OEM sensor, and confirmed the bake element was healthy. Recalibrated and ran a full preheat-and-hold test at multiple temperatures to confirm even, stable heat. On site: 90 minutes.
Our reviews
How to Book Your Repair
Three simple steps – we handle the rest
Contact Us Online or by Phone
Fill out the request form or call us directly. Tell us what appliance you have, the brand, and what it’s doing – or not doing.
Schedule a Convenient Time
We’ll confirm a visit window that works for you – same day or next day in most cases across the DFW area.
We Come and Fix It
Your technician arrives with parts for the most common repairs already on the truck. Most jobs are completed in a single visit.