Kenmore Appliance Repair in Dallas, TX
Reliable Kenmore and Kenmore Elite repair. We know every generation — from legacy units to the newest models — and stock the parts to fix them fast.
1100+
Which Kenmore appliances do we service?
All Kenmore Lines: Standard & Elite series — refrigeration, cooking, dishwashers, laundry.
Kenmore Washer Repair in Dallas
Kenmore and Kenmore Elite washers span top-load and front-load designs. A unit that won’t spin or drain usually has a drain pump, lid switch, or motor coupling issue; a top-load that won’t agitate points to worn drive cogs or a coupling; and a loud roar on a front-load spin means worn drum bearings. We know every Kenmore generation and stock the parts to fix them fast.
Kenmore Dryer Repair in Dallas
A Kenmore dryer that won’t dry is a common, fixable call. No heat traces to the heating element, thermal fuse, or gas igniter; a drum that won’t turn means a snapped belt; and a squeal or grind points to worn rollers or an idler. A dryer that stops early is usually a restricted vent triggering overheat protection. Most repairs are done in a single visit.
Kenmore Dishwasher Repair in Dallas
Kenmore dishwashers develop standing water from a blocked filter, hose, or drain pump; poor cleaning from clogged spray arms or a worn wash pump; and won’t-start faults from the door latch or control. We diagnose precisely and verify full drainage under a real load.
Kenmore Fridge & Freezer Repair in Dallas
Kenmore and Elite refrigerators commonly need attention for a warm fridge with a cold freezer (defrost system or evaporator fan), a dead ice maker (water inlet valve or frozen fill tube), or a slow water dispenser (valve or filter). A unit running constantly is usually a door seal or dirty condenser coils. We service top-freezer, side-by-side, and French door units.
Kenmore Stove & Cooktop Repair in Dallas
Kenmore gas, electric, and smooth-top ranges develop a familiar set of faults: a gas burner that won’t light (igniter or spark module), a coil element that won’t heat (the element, switch, or oxidized receptacle), or a weak oven igniter that glows but won’t light. We test and repair gas and electric units safely, and replacement glass is available.
Kenmore Oven Repair in Dallas
Kenmore ovens, including older legacy models, develop a failed bake or broil element, a worn gas igniter, a drifting temperature sensor, or a self-clean fault that trips the thermal fuse. We service every generation, source the right parts even for older units, and recalibrate.
Discount Coupon
Save on your next service with Home Appliance Repair Technician. Our primary aim is to make quality kitchen and laundry appliances as affordable as possible for everyone.
How we work
Brand-certified repair, done right the first time – your appliance back in service without the runaround.
Brands We Repair
Your reliable local partner for premium appliance repairs and expert maintenance.
Recently Completed Repairs
Kenmore Elite Front-Load Washer – Loud Roar on Spin
Lochwood, Dallas
The problem: A deep roaring noise during spin had grown louder over weeks, with a slight wobble during the cycle.
The fix: The rear drum bearing had worn down. Replaced the bearing and seal kit with OEM parts before it could damage the shaft seal and motor, then ran two spin cycles to confirm quiet operation. On site: 2.5 hours.
Kenmore Dryer – Cold and Damp
Casa View, Dallas
The problem: The dryer ran a full cycle but never heated, leaving every load damp.
The fix: The heating element had burned through. Confirmed the thermal fuse and thermostat were healthy, replaced the OEM element, and verified proper drum temperature. On site: 90 minutes.
Kenmore Dishwasher – Standing Water
Old East Dallas, Dallas
The problem: The cycle finished with water pooled in the tub despite a recently cleaned filter.
The fix: The drain pump had failed. Replaced the OEM drain pump, cleared the hose, and verified full drainage across a test cycle. On site: 90 minutes.
Kenmore Side-by-Side Fridge – Ice Maker Dead
Hamilton Park, Dallas
The problem: The ice maker stopped producing and the water dispenser had slowed beforehand.
The fix: The water inlet valve had failed — it feeds both functions. Replaced the OEM valve, flushed the line, and confirmed full water flow and ice production. On site: 90 minutes.
Kenmore Electric Range – Coil Won’t Heat
Pleasant Grove, Dallas
The problem: One coil burner stopped heating while the others worked normally.
The fix: The element receptacle below the cooktop had oxidized, causing poor contact — not the element itself. Replaced the OEM receptacle and element, and tested the burner through its full heat range. On site: 1 hour.
Kenmore Legacy Gas Oven – Won’t Heat
Winnetka Heights, Dallas
The problem: An older Kenmore gas oven igniter glowed but the burner never lit, leaving the oven cold.
The fix: The igniter had weakened below the threshold to open the gas valve — common on older ranges. Sourced and installed the correct OEM igniter, then verified current draw for proper valve operation. On site: 75 minutes.
Kenmore Top-Freezer Fridge – Fresh Food Warming
Owenwood, Dallas
The problem: The fresh-food section warmed over a few days while the freezer stayed cold.
The fix: The evaporator fan motor had failed, stopping cold-air circulation to the lower section. Replaced the OEM fan motor and confirmed restored airflow and temperature recovery. On site: 90 minutes.
Our reviews
How to Book Your Repair
Three simple steps – we handle the rest
Contact Us Online or by Phone
Fill out the request form or call us directly. Tell us what appliance you have, the brand, and what it’s doing – or not doing.
Schedule a Convenient Time
We’ll confirm a visit window that works for you – same day or next day in most cases across the DFW area.
We Come and Fix It
Your technician arrives with parts for the most common repairs already on the truck. Most jobs are completed in a single visit.