GE Appliance Repair in Dallas, TX
Certified repair for GE, GE Profile, and Café appliances. Trained technicians, OEM parts, and same-day service across refrigeration, cooking, and laundry.
1100+
Which GE appliances do we service?
All GE Lines: Profile, Café, Advantium, UltraFresh, Twin Cooling – we know every GE line.
GE Fridge & Freezer Repair in Dallas
GE, Profile, and Café refrigerators commonly need attention for a warm fridge with a cold freezer (defrost system or evaporator fan), an ice maker that won’t produce (water inlet valve or frozen fill tube), or a Twin-Cooling fault (airflow or damper between sections). A unit running constantly is usually a door seal or dirty condenser coils. We service top-freezer, side-by-side, French door, and Café units.
GE Dishwasher Repair in Dallas
GE and Profile dishwashers develop standing water from a blocked filter, hose, or drain pump; poor cleaning from clogged spray arms or a worn wash pump; and won’t-start faults from the door latch or control board. We diagnose precisely and verify full drainage under a real load.
GE Washer Repair in Dallas
GE washers, including UltraFresh front-load models, are reliable but develop issues. A unit that won’t drain or spin usually has a clogged pump filter or failed drain pump; a door that won’t unlock points to the interlock on front-load models; and a top-load machine that won’t agitate traces to the drive components or motor coupling. UltraFresh models can also develop odor around the door from a vent or gasket issue. We diagnose the real cause, install OEM parts, and run a full test cycle.
GE Dryer Repair in Dallas
A GE dryer that won’t dry is a common, fixable call. No heat traces to the heating element, thermal fuse, or gas igniter; a drum that won’t turn means a snapped belt; and a squeal or grind points to worn drum rollers or an idler. A dryer that stops early is usually a restricted vent triggering overheat protection. Most repairs are done in a single visit.
GE Oven Repair in Dallas
GE, Profile, Café, and Advantium ovens develop uneven baking, a failed bake or broil element, or an Advantium speed-oven fault tied to the magnetron or control. An oven that won’t hold temperature usually has a drifting sensor. We replace what’s out of spec and recalibrate.
GE Stove & Cooktop Repair in Dallas
GE gas, electric, and induction ranges develop a familiar mix of faults: a gas burner that won’t light (igniter or spark module), a surface element that won’t heat (element or infinite switch), or an induction zone that won’t recognize cookware (power board or sensor). We test and repair gas, electric, and induction units safely, and replacement glass is available for cracked cooktops.
Discount Coupon
Save on your next service with Home Appliance Repair Technician. Our primary aim is to make quality kitchen and laundry appliances as affordable as possible for everyone.
How we work
Brand-certified repair, done right the first time – your appliance back in service without the runaround.
Brands We Repair
Your reliable local partner for premium appliance repairs and expert maintenance.
Recently Completed Repairs
GE UltraFresh Washer – Persistent Door Odor
Midway Hollow, Dallas
The problem: The owner reported a musty smell from the door area even after running the UltraFresh self-clean cycle repeatedly.
The fix: The vent system that’s supposed to dry the gasket had a failed fan, leaving moisture trapped behind the boot seal. Replaced the OEM vent fan, cleaned and treated the gasket, and confirmed proper drying after a cycle. On site: 90 minutes.
GE Gas Dryer – Tumbles Cold
Far North Dallas, Dallas
The problem: The gas dryer ran a full cycle but produced no heat; clothes came out cold and damp.
The fix: The igniter glowed but had weakened past the point of opening the gas valve. Replaced the OEM igniter, confirmed the flame sensor and thermal fuse were healthy, and verified proper heat across a cycle. On site: 75 minutes.
GE Profile Dishwasher – Won’t Start, Door Seems Closed
Greenland Hills, Dallas
The problem: The dishwasher wouldn’t begin a cycle even though the door appeared to latch normally.
The fix: The door latch switch had failed, so the control board never received the ‘door closed’ signal it needs to start. Replaced the OEM door latch assembly and confirmed reliable cycle start. On site: 1 hour.
GE Café French Door Fridge – Fresh Food Warming
Royal Highlands, Dallas
The problem: The upper fresh-food section climbed to unsafe temperatures over a few days while the bottom freezer stayed solid.
The fix: A defrost system failure had let ice block the evaporator. Cleared the ice, replaced the OEM defrost heater and sensor, and confirmed restored airflow to both compartments. On site: 2 hours.
GE Induction Range – Zone Errors After Surge
Hamilton Park, Dallas
The problem: Two cooking zones started erroring and wouldn’t heat after a storm-related power flicker.
The fix: The voltage event damaged the shared inverter board. Confirmed the coils and sensors were intact, replaced the OEM board, and tested all zones with compatible cookware. Recommended a surge protector. On site: 2 hours.
GE Top-Freezer Fridge – Water Pooling Inside
Elmwood, Dallas
The problem: Water kept collecting under the crisper drawers and occasionally dripped onto the floor.
The fix: The defrost drain was frozen and blocked, so meltwater overflowed instead of draining. Cleared the drain, installed an OEM drain heater clip to prevent refreezing, and confirmed proper drainage. On site: 90 minutes.
Our reviews
How to Book Your Repair
Three simple steps – we handle the rest
Contact Us Online or by Phone
Fill out the request form or call us directly. Tell us what appliance you have, the brand, and what it’s doing – or not doing.
Schedule a Convenient Time
We’ll confirm a visit window that works for you – same day or next day in most cases across the DFW area.
We Come and Fix It
Your technician arrives with parts for the most common repairs already on the truck. Most jobs are completed in a single visit.